FlyingGiants - View Single Post

QSPILOTCMH · 09-04-2009, 08:11 AM

Hello,

I am building a 25% Su-26 with a DLE30 motor which I purchased from Valleyview RC my first gas airplane.
http://http://www.valleyviewrc.com/Sukhoi%20Su-26m.htm

I am planning on using an A123 pack for the rx to keep things simple and light. Any suggestions on where to buy it and what size? What type of switch should I run?

Any suggestions on servos? Valleyview RC recommended HS645. Do you think they would be sufficient or should I look at the HS5645 or HS7985. The plane should weight around 10-11 LBS when completed. I like to 3D and fly pattern. I would hate to build a good airplane and put a cheap servo into it causing a poor flying airplane.

Thanks!

09-04-2009, 08:11 AM	#1
QSPILOTCMH Gettin' Lower! Join Date: Jun 2008 Location: United States, FL, Tampa Age: 39 Posts: 67	25% SU26 Setup help Hello, I am building a 25% Su-26 with a DLE30 motor which I purchased from Valleyview RC my first gas airplane. http://http://www.valleyviewrc.com/Sukhoi%20Su-26m.htm I am planning on using an A123 pack for the rx to keep things simple and light. Any suggestions on where to buy it and what size? What type of switch should I run? Any suggestions on servos? Valleyview RC recommended HS645. Do you think they would be sufficient or should I look at the HS5645 or HS7985. The plane should weight around 10-11 LBS when completed. I like to 3D and fly pattern. I would hate to build a good airplane and put a cheap servo into it causing a poor flying airplane. Thanks!