|
|
|
|
|
|
|
Not 90degs to the suface.The hindge line.If you're links are the same length like there supposto be and you angle the arms forward woun't you get less up and more down?That's with equal amounts of atv of cource.I've setup at least two of these radios with dual elivators and it's a pain but will work,and work with any servo too.I never had a issue with what servo i was using jr,Futaba<hitec done them all .Mechanical geometry is were you start everything equall.The only time I've ever used diffrent length links is when useing dual servos on a serface.The inside are usually shorter but both right and left inside servo links were matched. |
|
|
|
|
Servos are mounted in the fuse, not the stabs, so there is no "parallel" to the hingline. They must be mounted like my post above, or equal travel is impossible.
Seth