FlyingGiants - View Single Post - New Hitec HS-7990TH "ME" Magnetic Encoder 12 bit servo

Mike Mayberry · 10-30-2009, 01:26 PM

Here's a teaser for the next generation servos from Hitec. This servo is slightly larger (10%) than the standard size but it allowed us to push the torque output to the next level as the standard size cases are nearing their limit.

To go one step further we replaced the mechanical pot with a magnetic encoder... next gen baby!

Specs: .18sec@639in/oz at 7.4V.
Price: $199.99

There will also be a 7980TH without the magentic encoder but with the same specs that will be $179.99.

Shown here next to the new 7915HB (.05@75in/oz at 4.8v) tail rotor servo which uses the same case as the 7950. Of course these use ALL Titanium gears, not just on the output shaft like some other brands claiming Ti gears.

Mike.

10-30-2009, 01:26 PM	#1
Mike Mayberry Bad-ass Super Contributer! Join Date: Mar 2006 Location: Poway, CA Posts: 704	New Hitec HS-7990TH "ME" Magnetic Encoder 12 bit servo Here's a teaser for the next generation servos from Hitec. This servo is slightly larger (10%) than the standard size but it allowed us to push the torque output to the next level as the standard size cases are nearing their limit. To go one step further we replaced the mechanical pot with a magnetic encoder... next gen baby! Specs: .18sec@639in/oz at 7.4V. Price: $199.99 There will also be a 7980TH without the magentic encoder but with the same specs that will be $179.99. Shown here next to the new 7915HB (.05@75in/oz at 4.8v) tail rotor servo which uses the same case as the 7950. Of course these use ALL Titanium gears, not just on the output shaft like some other brands claiming Ti gears. Mike. Attached Thumbnails 107.5 KB · Views: 384 111.5 KB · Views: 203 91.3 KB · Views: 169 Last edited by Mike Mayberry; 10-30-2009 at 01:35 PM.