|
Quote: Originally Posted by 3D-Seth |
|
|
|
|
|
Page 7, 1st picture. 
Do you really believe all that facebook crap Chris?
 |
|
|
|
|
If it come from Craven, then it is the TRUTH!!!! BWAHAHAHAHAHAH!!!!
"Glue all of the control horns in place with CA. All pushrods are made as shown below. Use the .032 wire to make the Z ends. Install the Z ends to the control horns and servo arms. Test fit each carbon rod and trim as needed. Add a small drop of CA to the carbon/wire joint. The 1/16" heat shrink is used to secure the 1mm carbon pushrod to the .032 wire.
Make sure the control surface and servo are centered before heating the shrink sleeve. Any adjustments past this point must be made with the sub-trim function of your computer radio."
Not contradicting you, YBA, just saying............
Now, go row your boat!!!