FlyingGiants - View Single Post

excelpoint · 01-19-2006, 01:02 PM

I havnt tryed this yet but if you were to put a bit of fuel tubing over each needle and left it about 10mm longer then you would be able to slip your screw driver into it and it would hold it there even when the engine was crankin. Might give it a go on the weekend. Anyone else got any ideas?

01-19-2006, 01:02 PM	#14
excelpoint Mother Hucker + Join Date: Jan 2006 Location: australia Age: 38 Posts: 2,407	Re: Gas engine tuning for newbies.... I havnt tryed this yet but if you were to put a bit of fuel tubing over each needle and left it about 10mm longer then you would be able to slip your screw driver into it and it would hold it there even when the engine was crankin. Might give it a go on the weekend. Anyone else got any ideas? __________________ (ASAA) www.scaleaeros.com.au DESERT AIRCRAFT AUSTRALIA: NUMBER 1 FOR PRODUCT AND CUSTOMER SERVICE.