FlyingGiants - View Single Post

GlennCS1 · 09-09-2006, 06:41 PM

Hi all

I am looking for suggestions for fitting out a hanger 9, 46% ultimate mainly in the area of control horns and linkages for the ailerons, pull-pull system on the rudder to a servo gang tray and coupler linkage system and lastly a tail wheel assembly.If possible I would like sites to where I can purchase these items. I will be using the Hitec 5955 on all the control surfaces.
This is the first giant aircraft I have put together so I am somewhat flying blind of what to do and where to go in sourcing parts and so on and want to try and get it right first time round.
any help would be greatly appreciated

Regards Glenn

09-09-2006, 06:41 PM	#1
GlennCS1 Flyin' Around Join Date: Jul 2006 Location: Perth Western Australia Age: 40 Posts: 29	Fitting out a 46% Ultimate Hi all I am looking for suggestions for fitting out a hanger 9, 46% ultimate mainly in the area of control horns and linkages for the ailerons, pull-pull system on the rudder to a servo gang tray and coupler linkage system and lastly a tail wheel assembly.If possible I would like sites to where I can purchase these items. I will be using the Hitec 5955 on all the control surfaces. This is the first giant aircraft I have put together so I am somewhat flying blind of what to do and where to go in sourcing parts and so on and want to try and get it right first time round. any help would be greatly appreciated Regards Glenn