Is there anyone that has this plane and used a DA-35 on it?

I've been looking for the answer to your question too. I found this thread, http://www.3drcforums.com/showthread...oDo-quot-Segev, they have some pictures and reviews from people using gas engines with the airplane. I want one too, but I want to see a video or something before making the desicion to spend the $750 for it. I hope this thread will give you an idea.

Originally Posted by vegasking1961

Is there anyone that has this plane and used a DA-35 on it?

Guys down here in oz are running them on gas including a DA35.

I've finally had time to work on this plane and it has been a small challenge to get everything into this smaller sleeker fuselage. On a 1-10 scale I'll give this a 8.5 overall, everything went together really good and seems to be very good quality, except the some of the hardware. Two of the metric pushrods weren't threaded correctly the threads must have been rolled instead of threaded with a die because the had rings instead of threads, I found this out when I tried threading the ball links on and they wouldn't go on and on a closer look just had rings that went no where. Other than that it went together pretty easily considering I had minimal build info. Hope to maiden in the next few days.

Finally maidened the Articulate and wasn't all impressed with it, it sure looks better than it flew on the maiden. It has a bad case of wanting to roll inward during a knife edge. The DA-35 had to be retuned to run right because of the slim cowling not allowing a lot of air for the carb and I still haven't got it 100% correct because it died at the end of this video.

https://www.youtube.com/watch?v=OyN59Q6AxQA