I'm setting up my first gasser, an H9 Extra 260 with a DL50 and will be using 2 MPI switches. The instructions says to connect the Miracle switch to the charge jack and receiver then attach the receiver battery to the Miracle switch. No mention is made of how to adjust the voltage. Not very detailed instructions at all so I am requesting some assistance in getting these units set up. Thanks in advance.

Keith

Keith -- You can't adj the voltage with the switch. You adjust the voltage by what type of pack you use (4 cell 4.8 volt or 5 cell 6 volt for example) or by using a voltage regulator if you have a high voltage pack.

Do you have the MK2? If that is the one, there should be a blue pot with a yellow dial in it that you can turn to adjust it.

Thanks guys. I do have the MK2 Regulator with attached Switch. I did figure it out though, I was testing the voltage from the charge jack on the switch and not the output from the MPI requlator. I'm getting there slowly.. Thanks for the responses.

Keith

Originally Posted by kwcollier

Thanks guys. I do have the MK2 Regulator with attached Switch. I did figure it out though, I was testing the voltage from the charge jack on the switch and not the output from the MPI requlator. I'm getting there slowly.. Thanks for the responses.

Keith

hi hello look i gonna use that regulator how many batteries you have to your Rx i whant to use 2 Li Ion batteries of 2cell and 2600 mah with a wolverine switch and only one mk2 regulator because the have to take to batteries or that its what i saw in the picture on TBM

Its good that configuration o not? my plane is a 30% toc yak 54

Forget it. It's a different switch.

Help Can some one draw a picture of a diagram of a Miracle Switch MK2. I have a 50 cc gasser its a GeeBee R-3. My email , is rayraydune@gmail.com Thank You.