Hi Guys, need some help, don't laugh please. The instruction manual (hate them) said I was to hook up my Right Elevator in Ch 3, the Elevator pin on the receiver, that of course went well. However, the Left Elevator in to be hooked up to Aux 1. I'm using a SmartFly and Aux 1 on the receiver is connected on the SmartFly to a given Channel. So I connect the left elevator servo lead to that channel on the SmartFly. But when I go into the tranx menu to slave the Right Elevator to the Left Elevator through Aux 1 as the picture in the manual shows, I do not find an Aux 1 no where in the Prog/Mix area to use. What am I doing wrong? Thanks for your help. Chic

Doesn't that radio use mates like the 9303 and 11x?

Originally Posted by BarracudaHockey

Doesn't that radio use mates like the 9303 and 11x?

Yup, but throwing a PE into the mix could confuse things....

But still, you could use chanel 3 and 8, activate the Dual Elevator function, and then plug any PE lead into channel 3 and 8 on the Rx. Be happy and done.

Are you using dual ailerons? If so the left aileron will use aux1 so you won't be able to use aux1 for elevator.

OK, OK, I broke down and thoroughly read the manual. It took several attempts and resets but I went through the sequence and the whole system works very well. Thanks to your inputs and a bit of reading. Chic