|
|
|
Donnie always has great ideas that seem to speed up a build, He is the one that talked me into the 37% Edge with my ole trusty DA 85. The foam really does work great! I have my baffles 1/16" away from the engine cylinder and it has not tried to discolor or deform. As an added bonus the foam is very light as well as very inexpensive.
|
|
|
|
|
Glad to hear this plane is working out with the 85 for some, didn't see that I could get mine to balance... Maybe I can after all.... Donnie, can I get a refund on a lightly used 100 ?
Jason |
|
||
Brazil, São Paulo, Sao Paulo
Joined Feb 2007
69 Posts
|
Quote:
Congrats for the plane, very clean and nice setup. Best regards, Alexandre Fusco |
|
|
||
|
Quote:
Thanks for the feedback... I was planning on using two 7954 on the rudder but might switch to one 7980 if needed to balance out the CG. |
|
|
|
|
|
|
|
|
FYI I just put mine up for sale at a great price.
https://www.flyinggiants.com/swapsho...?product=29198 |
|
|
|
Bryan I would love to have your Edge. Do you ever travel towards Indiana? Wish you were closer.
|
|
|
|
Got me an Edge over the weekend. I was going to wait for the white and blue one, but Stuart ( show871 ) decided to sell his. I loved his scheme the first time I saw it. Not too many flights were on that bad boy so I picked it up. Need to finished removing some decals and add my own graphics to it. Need to order up all the electronics and motor for it this week. Weather has been crappy, so I'm not in a big hurry. Beautiful plane though! I'll post my setup and new pictures once it is completed.
Here's what I'm looking at installing: DLE111 motor with stock mufflers Vess 27B prop Smart Fly EQ6 Turbo Board Hitec HS7955TG servos HS5625MG on throttle Twisted servo extensions from Troy Built SWB servo arms Fuel tank will switched to a Fortitude or will make one from a Fiji bottle. Great Planes 38% 330 pilot figure Bad Brad will do up the graphics I will need Cory |
|
|
|
I just got some for my PRC Extra 330SC its a buck a sheet. Kewl stuff.
|
Currently Active Users Viewing This Thread: 2 (0 members and 2 guests) | |
Thread Tools | |