|
|
Joined Sep 2008
3 Posts
|
DLE 55 - Ignition sensor
I removed the ignition sensor on my motor to apply thread lock, put it back . Motor runs great, then later realized I had not put sensor back to original position. I had slid plastic piece other direction and tightened there. So, my question is will this affect the timing, performance etc. How can I be sure I get it reset, to where it needs to be. This is a new motor, and starting break-in process. Thanks for any info.
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Bad ignition or Hall sensor | s3nfo | Gas Engines | 3 | 08-22-2009 12:23 PM | |
cant get my dle 55 started | excel86 | Gas Engines | 15 | 06-23-2009 12:54 AM | |
brand new dle 55 hard start | excel86 | Gas Engines | 10 | 06-20-2009 01:25 AM | |
Eagletree rpm for ignition w/ brushless sensor? | JB Rekit | Onboard Electronics | 1 | 03-29-2008 06:41 PM | |
Eagletree rpm for ignition w/ brushless sensor? | JB Rekit | Gas Engines | 2 | 03-28-2008 10:32 AM |