Hey guys what size wire are yall using from your battery to your power interveter and then from where the inverter attaches to the 12 volt power source it will also run my my two set of banna plugs that will run my chargers and my Chargers will only do 4 amps apiece at the most...

i use 18 gauge speaker wire and one plug i doubled it up for extra current abilities. These are only used for charging 2s flight packs. I have a 120 VAC setup with a power inverter for charging 4s and 6s packs.

Sub

I run all my chargers off of my on board 100amp marine battery. Check out some of my pics close to the last page of the trailer thread. I think its 14g wire, but it runs a banana outlet on the front work bench that's right above the battery and then there is one at the back of the trailer that I use with an extension cord I made to charge planes on the ground outside of the trailer. No problem so far charging 4 li ions at 2.6 amps and a 2 life at 2.1 on 2 planes with 2 hitec chargers, all at the same time. That puts a hurt on the battery, but I just installed a nice solar panel to put juice back in the main battery. We'll see how that works out.

i did 12 ga from batt to my fuse and then 14 ga from there on out cause thats the wire I Had lol with inline fuses