Were did you get the stack from,,

Paut 2 more flights on the engine yesterday, I think I am very cose now with the needle settings. High @ 2 turns and Low @ 1 turn. Using a 19x8 prop. The engine is in a QQ 73" Yak. Almost all flying was done at 1/2 throttle. Getting to be very happy with this engine now.

Nice looking Yak...

I got a Intake stack like the one in the photo from Horizon Hobby. About $3.

Does anyone have the 4 mounting hole dimentions for the DLE 30 handy? Thanks Capt,n

Here.

Originally Posted by jongurley

Were did you get the stack from,,

Mine is from dl engines here in aus, But i think it will be pretty easy to get

See the stack on thread 3688. It has an angle at the opening. I don't know if I should scope in air or shield the opening.

A stack from B&B is two parts and can be rotated..The lower side should face forward..Backward pulls fuel out..

Here is what I did with the DLE30 rear intake engine. I made stand-offs .700 inch long with 1/2 inch Dia. I added a 1/4 to firewall...that is now 1/2 inch thick. I made the hole for carb in added fire-wall ....then epoxied it to existing fire-wall. That places the adjusting needlles just inside. Drill a hole to adjust from outside of fuse. Capt.n





Note...add .050 to the length of the standoffs...for exhaust box to fire-wall clearance

Here is the yak with decals

sgoen
That sure is a nice looking Yak....I got to get one next time around! Capt.n

Originally Posted by Captinjohn

Here is what I did with the DLE30 rear intake engine. I made stand-offs .700 inch long with 1/2 inch Dia. I added a 1/4 to firewall...that is now 1/2 inch thick. I made the hole for carb in added fire-wall ....then epoxied it to existing fire-wall. That places the adjusting needlles just inside. Drill a hole to adjust from outside of fuse. Capt.n

Attachment 282810

Attachment 282811

Captinjohn
Have you run your dle30 yet I would like to know how it runs, thinking about getting one
have not found much info on them yet with rear carb.
Paul

I just received my velocity stack from atvantage hobby for my dle-30. Is the proper way to mount this for the side carb is to have the short side of stack facing the prop?

Originally Posted by ML3614

I just received my velocity stack from atvantage hobby for my dle-30. Is the proper way to mount this for the side carb is to have the short side of stack facing the prop?

The lower side should face forward..Backward pulls fuel out..

yup

Any video's and prop numbers with the DLE30 on a ES Composite tuned pipe???