throttle = 1
elevator =1 or 2 (Y if needed)
ailerons = 2
rudder = 1
battery = 1 or two ( Y into a, lets say rudder channel)

You should be good on channels I would run two batteries. But that is just me.

Originally Posted by dynofly

I bought the plane already built with 4 ailerons and one servo in each. There is no rx with the plane. So i am trying to figure out the hookup. I will use the 2 Y's method on chanel 2 & 6 as suggested. (KISS) Now I just need to be sure to buy a rx that will work, my tx is a Spektrum DX7. So a 7 ch rx will work with an aux to spare no?
Thanks for all the help.

I'd buy the 7ch RX as well, even though you could get by with a 6ch...Sounds like you got a plan... You will enjoy that Aeromaster...very nice flying plane.

I just used y cables for the ailerons on my 30 cc ulti. it works fine. with ignition kill and choke servo i used 7 channels.

Run 2 rx I don't trust a y I ran 2 7000 in my qq python and it saved it

Originally Posted by Unmanned

Until you try to center them individually.

That's why they have threaded rod!!

But the you can have different throws. Then again, if you understand bipes, different throws (top and bottom wing) are a good thing as long as they are in the right places in the right amounts.