|
|
|
Discussion
EQ6 throttle issue
ok here what the issue is I had to change the caps on my dle ignition to run the 14mm plugs in my brison and when I went to start the motor it went full throttle on its on no mater where I move the stick this is confusing and has me stumped worked fine tell just a cupple days ago
|
|
|
|
|
Putting new plug caps on the ignition and a extension on throttle servo should have nothing to do with the EQ6.
Sound like user error to me and the servo isn't hooked up right or even plugged in. . Things to check. #1 : Is the servo plugged in ? #2 : When you put the extension on the throttle servo, do you have the polarity correct ? #3 : Do you have the extension plug into the EQ6 correct polarity ? #4 : Do you have the extension plugged into the right port on the EQ6 ? #5 : Is the extension bad ? Broken signal wire ? #6 : Does the servo operate correctly with out the engine running ? |
|
|
|
I hope that you had the plane in a restraint ?
Another hint, I always check that all servos are working before I start my engines. |
|
|
|
Did you install the plug caps properly? Resistor and all?
|
Currently Active Users Viewing This Thread: 2 (0 members and 2 guests) | |
Thread Tools | |