Where do you buy these?? - my planes look like rats nests inside....

Hangar 9 has them and also JTEC sell them as Clamp Loc's. They have them various sizes.

I use some sticky back velco to lay down where I need, then one wrap velcro on the cable. When going thru formers, I use 1/4 square balsa, sand a groove on the bottom so one wrap velcro will pass and epoxy the balsa down.

Airwild has them also

those are wire keeps you can find them here at Plane Addicts under the hardware section. I would post a direct link to them but I am using a mobile device sorry.

Tom

Don's Hobbies also

slide a small peice of tubing over the wire and attach with hot glue.

Thanks for all the help!

I have also found several types of wire hold downs at Electronics
stores (Radio Shake or real ones...)

http://shop.aztechaeromodels.com/Spo...ps-AA-TRWK.htm

They come in blue and red. The blue has a little bigger hole for larger wires while the red has a smaller hole.

They work great.

I use the Aztech ones, and they work very well. I put a drop of CA behind each one just for added insurance, but they are plenty sticky regardless. I have the larger size, and they hold fuel tubing, servo extensions, and even my spektrum satellite leads.

I too use the foam Aztech Aero ones...

I have used the one's from Don's Hobby and also, Home Depot, in their electrical section, have some neat hold down's that you can run a zip tie through. Work great for bundling wires also.