|
|
Joined Jun 2007
73 Posts
|
Please Confirm My Optical Kill Setup is Correct
I just bought my first gasser, a DA-50 powered Airwild Extra 260. The current set-up doesn't have an ignition kill so I am adding one.
I bought the Smart-Fly Optical Kill last night. I've read the How To Article on Rc Universe linked from the product info page, as well as the manual you can get on the Smart-Fly web site in the Instructions section. However, I just want to double check my planned setup because neither the How To or the Manual specifically deals with what happens when you are Regulating the battery. The instructions are simply: "It must go between the ignition on/off switch and the ignition module." Here is the planned setup: 2600 Lion Battery > Switch > Regulator > SMARTFLY OPTICAL KILL > Ignition Does that look right? Just want to make sure the Kill should come after the Regulator and before the Ignition and not after the switch and before the Regulator. Thanks for your patience. I am newbie and this this is my first Optical Kill and gas engine and only my second entry into the world of Lion and Regulators. |
|
|
|
|
Re: Please Confirm My Optical Kill Setup is Correct
You got it right
|
|
|
|
Re: Please Confirm My Optical Kill Setup is Correct
Just remember if you set your failsafes to last known position......Ensure the Optical Kill is setup correctly before you set that. Otherwise it will kill your motor
|
|
|
|
Re: Please Confirm My Optical Kill Setup is Correct
Looks right to me!
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Smoke Setup: How To | 3Dkid330 | Gas Engines | 8 | 03-26-2021 10:38 PM | |
Smart Fly Optical Kill Switch | storklappe | Onboard Electronics | 30 | 03-26-2009 05:03 PM |