Norio79- If we did not reply then we must not have received it as we answer every e-mail we receive.

Henke- We have tested it with our system and cannot duplicate the problem.

Mike.

Originally Posted by 3daviator

Yes, that was one of the ones I looked at. Good wire, just not as many strands or as big of strands as the mentioned MPI. It might test out as well as the other, but I just went with the bigger is better theory for now

Good to know thanx.

Hi all,
Anyone had any issues with 7950TH?

Regards
Meshari

Originally Posted by Mike Mayberry

Henke- We have tested it with our system and cannot duplicate the problem.

Mike.

We tested on a LiFe today which is about 6.6volts, still glitching

I will upload video and pix of the setup soon.

I have not had any chance to try the ferrite rings yet.

It seems like Henke is the only one with this issue. Why not send it back to Hitec and have them look at it?

Originally Posted by henke

We tested on a LiFe today which is about 6.6volts, still glitching

I will upload video and pix of the setup soon.

I have not had any chance to try the ferrite rings yet.

Have you tried them at 6v yet to see if they glitch?

Originally Posted by STLAV8R

Have you tried them at 6v yet to see if they glitch?

That defeats the purpose of these servos.

deleted

As far as wire goes air wild has silicone wire that is the heaviest gauge with the most strands. Comes in bulk 50' lengths for about $28

If you look back you will see that i also posted issues with the glitching. I've tried nearly everything. I did try jr chokes after twisting the wire seemed to improve things, it didn't eliminate the problem. seems that anything over 6volts is iffy at best.

Originally Posted by Flatlandman

That defeats the purpose of these servos.

I agree. But just curious if they still glitch....
Is it the voltage, the servo extension, or the servo itself?

Guy am going to make me some extension with airwild 22 gauge wire and I will hook up my two 7950 on the rudder of my Dalton tonight. I'll let you know if I get any glitching. I be using a jr 922 rx with a 5200 fromeco lipo

Could be a batch related issue

Originally Posted by rcflyer

Could be a batch related issue

Thats what I am thinking,, I have 12 servos around my area,, one guy has 4 on 7.4v no twisted extensions,, they are fine,, the others are mine on 6.6volt A123 some extensions are twisted some are not,, no problems,,

I tired a ferrite ring on the extention. I doesn't seem to help. The servo I got is fine under 8.2v. I got the first ones from Chief Aircraft. Anyone else?