|
||
|
Quote:
|
|
|
|
|
|
Nothing but the best for my new Slick
|
|
|
|
|
|
|
|
I had one leak after about 5 flights, inside of plane was covered in gas. Pay attention to the o-rings on the fittings. Nice thing is you can see them. I've also had one last several 100 flights with no issues so not bashing just sharing my experience.
|
|
||
|
Quote:
any my damn clunk is to short i need to re pump it ... and i'm looking for 2" off the back the tank |
|
|
|
|
Back at the first of this thread in 2011 there was talk of making some other size tanks 20, 24, 50, 60. It is now 2014 and there are still no new sizes of tanks. What gives?
All I use is Fourtitude tanks with the exception of my 40% IMAC plane. I can't run 2 tanks side by side because as the flight progresses one side of the plane ends up heavier than the other side. Yes, it makes a difference. I did have one tank that right out of the package the vent fitting had a split o-ring and dumped fuel inside my plane when I fueled it. Replaced the o-ring and all is well. |
|
||
|
Quote:
|
|
|
|
|
.
|
|
|
|
I just ordered a 32 ounce for my 104 Extra.
Nice tanks. |
|
||
Van Nuys, CA
Joined Jun 2006
1,022 Posts
|
Quote:
Jason is a great guy to deal with! few months ago I asked him some question about a custom made tank tray to keep nr. 3 32 os tank side by side for my 50%BH cub and he was very helpful. I ended up making my own tray because was not very practical to start shipping parts back and forth across the ocean (I'm in Italy now..) but I'm sure if I asked him to make the tray he would do that. I even sent him some photos of my installation and he never reply.... now I know why. Jason, I wish you all the best and I hope very soon everything will go better than ever! CIAO Daniele |
|
|
|
|
If I remember correctly, Jason told me one time......it costs around $12,000 to have a mold made. You gotta sell a mountain of existing sizes to pay for that kinda project.
|
|
|
|
Get ahold of 4titude...I'm sure he'll help you out
|
|
|
United States, CA, Loma Linda
Joined Nov 2014
74 Posts
|
Could someone explain where each line connects to please, I notice some tanks have three lines and some
Have two With a T connector for fill and carb. I like the three line set up in just confused as to which line goes where, one must be carb and one is vent, |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |