logo
Thread Tools
Old 02-22-2015, 04:50 PM
jstanton is offline
Find More Posts by jstanton
Registered User
Millington, TN
Joined Apr 2007
163 Posts
The weather cleared up enough today to test run the EME 35cc. This is a great engine. I have a Turnigy 19x8 wood prop on it for break-in. I am using Stihl HD synthic oil at 32 to 1. I ran the engine for three 10 minutes runs and the engine ran better after eacj run. I gave the EME 35 10 minutes rest between run's. I am getting a good idle at 1550 and I did WOT for a few seconds on the third run. The top end was 6800RPM. The setting are still very rich. It is very cold here in west TN and I had to richen up the high end over the factory setting to get it to run at Top end. So far I am very pleased with this EME 35
jstanton is offline Find More Posts by jstanton
Reply With Quote
Old 07-27-2015, 10:47 AM
gabe221 is online now
Find More Posts by gabe221
Tree Hopper
gabe221's Avatar
United States, TN, Dresden
Joined Nov 2014
64 Posts
Any updates on prop sizes? Which is best?
gabe221 is online now Find More Posts by gabe221
Reply With Quote
Old Yesterday, 09:29 AM
jstanton is offline
Find More Posts by jstanton
Registered User
Millington, TN
Joined Apr 2007
163 Posts
I have 3 of these EME 35's and all are running great. I have found that a 20x8 Xoar prop gives the most thrust at over 20lbs. I have a new EME 35 on a Fly-Model Yak 54 that weigh's in at 11.5 lbs. I am running a VV 19x8 prop on it for break-in and I am getting 7200RPM at top end with a good 1700 rpm Idle. I measured the thrust at 19lbs which makes this Yak do anything I want an it is not even broken-in yet!
jstanton is offline Find More Posts by jstanton
Reply With Quote
Old Yesterday, 10:08 AM
gabe221 is online now
Find More Posts by gabe221
Tree Hopper
gabe221's Avatar
United States, TN, Dresden
Joined Nov 2014
64 Posts
Reason for asking, I am going to install one on a H9 Valiant. More sport flying than anything. I was looking at the electric starter version, wanting to make the order and get the prop I needed as well. So a 20x8 is what's needed.
gabe221 is online now Find More Posts by gabe221
Reply With Quote
Old Today, 08:14 AM
jstanton is offline
Find More Posts by jstanton
Registered User
Millington, TN
Joined Apr 2007
163 Posts
A 20x8 will give you the most thrust but I would break the engine in using a 19x8 at first than do to the 20x8 after a gallon for fuel have been run threw the engine. I am still breaking in my EME-35 on my Yak 54 and it fly's very well. Just a few more tanks of fuel threw the engine and a Xoar 20x8 will be going on.
jstanton is offline Find More Posts by jstanton
Reply With Quote



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools