|
|
|
|
mogman, You might try to contact www.davebrownproducts.com I have a 6" also in a P-51 type
spinner from him but he might make you one special order. Worth a shot. Steve Mullis |
|
|
|
out of curiosity....why the needed extra 1/4"?
|
|
|
|
Big Spinner
You might try Joe Z at Zinger Propellers Joe@zingerpropeller.com
He has an alum 6" ($47)as well as a 6-3/4" ($50) that could be cut down and a new backplate made. Give him a call. Not a tru turn but they are good spinners and a very reasonable cost. Only drawback is they require screws around the backplate edge. |
|
|
|
|
|
|
|
Oh ok, I figured it may be for a scale look.
1/8" will be hard to pick out, even you will prolly dismiss it after a a short amount of time. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |