I've got a big problem with the servo. From Japan I ordered 4 new MP82S MKII, two of them I put on the Elevator. When I arrived to set up the plane for ten minutes after switching on the servo as the description went around the center( groggily ). But over time, he began to deviate from the center more and more and in the end broke down, ten minutes later down came the second servo, the link to the video

MP82S MKII WIDE VOLTAGE BRUSHLESS SERVOS, problem. (1 min 44 sec)

. The rest of the servos I'm afraid to put on a plane, because I think what happen to them, too. What do I do ?????

Well if you happen to have a way of hooking them up to a different radio I would try that first just to make sure it is in the servo. My bet it is by watching the video to. Then I would send them back to where you got them and get them replaced. If they will replace them and give you a choice I would get the nx servos. That way you can program the gains to take out chatter also

What is your input voltage ?

Bob

Well. But unfortunately I was sent on a business trip and will arrive home in just three weeks, this deadline can wait, right ??? Power 2S LiPO ! the manual says that it is possible for 4.8-8.4 volts

Hello. Yesterday while I was at work, came to me from a friend., he has a HITEC AURORA 9x transmitter. So nothing has changed, everything remains the same (((

I have 3 of these servos and not one glitch. About 10 flights on them.

Bypass your servo extensions.

Mine are on 36" extentions.

Did it do this on the bench at home ?

Originally Posted by as722

Did it do this on the bench at home ?

home a lot of places and it allows me to do.

here, view description

This function is to avoid any potential damage to the linkage on Giant scale airplanes with the moving surface of wings.On initial power up this servo returns to the neutral position very slowly to avoid this problem.

* Do not use this servo under the different voltage other than specified
* If used on a large control surface - typically aileron, rudder, elevator or flap on an airplane, Digital servos (DS · MP · MPH series) may move slightly around center while on the ground. This is an expected phenomenon, and will not occur in the air.
this effect was, but then he became more and more.

Originally Posted by tandberg007

I have 3 of these servos and not one glitch. About 10 flights on them.

you had this effect ??

Originally Posted by as722

Did it do this on the bench at home ?

little space, but enough to check

Hello. Continuing the theme,I sent these servo to Japan, where they looked at them and wrote the following "Actually, one of the servo is damaged on B-gear and the other servo is being locked. So We cannot repair them, but as a special case, I will replace these 4 servo as latest servo new NX8931, I am sure this will satisfy you."