Ah, but Biff you MUST know that for flying, you have to have a completely different set of glasses, and they have too look like this ... i'm not sure how those would do inside though.

Unfortuantely for me, my flying and golf have both suffered as a result, I wear Smith's.

Back to the Sypher, Beavis, is that a custom built Sypher transport? looks like that plane could be a bit of a tricky one to haul around.

Hey Max, Did you get any video of Beavis doing the demo on friday night when he faced the bleachers and did a rolling circle? Now that was bad a$$

On the Sypher guys. I have one, and am having difficulties on getting radio installation down.

Rx inside or outside??? Lipo inside or outside???

Looks like alot of wiggle and fit with Lipo pack! Other than that, it is a great design, and EASY to assemble!!! Wish mine was ready......... UGH!!!

Chris~

The top of the fuse behind the motor should be a hatch plate and the battery slides in.

Maybe Asher can post a couple of pics. Hint hint

Chris,
Put the rx inside right where the hatch is. If you notice all the wires have a slot to lead right there. Battery there are many ways to do it. Mark and Chip have the top of the fuse as a hatch and just slide the pack down in the fuse with a slot to keep it in place. I ran mine thourgh the fuse an velcro'd it to the fuse longeron. Both work well. I also found that putting the pack on the bottom of the longeron keeps the vertical balance in check. I wish I had a picture. Not able to post that right now. There is a Memphis EAC gallery on rcg that has tons of pictures. If you can find that it will help you understand some of the setups. One last thing the speed controller location. Get some air over that bad boy!! With 4 servos and inside a fuse it needs more than you think. Mine thermal overloaded at the ETOC doing a snap in my freestyle round. All because it just wasn't cooling properly. You're going to love that plane. Speed varances will really change the things you can do with it. Thats how Beavis did the rolling behind his back deal. You get the speed just right there is no pilot load at all. Unreal how well it does everything. Getting pumped up for the XFC!!!! Jason

I will try and get up a few pics as soon as I can!

What schemes are available for this plane?

WHITE

I am working now with someone on getting my planes laser printed but will be at least a couple of months until there are in production with a scheme. The yak is the only one now that has a print. pics of the hatch coming later.

here are some pics of the hatch. Not very good though. They are from my phone....

Looks good enough for me to get back up and runnin next week.

Appreciate your efforts, Jason!!!

Chris~

Hello guys!

I really like the Sypher, but I can't see it on insanefoamies website, and I can't contact with them by email (I receive an error message when after I send it). What should I do?

Thanks, and keep the Sypher photos coming!

Does anyone have a video of the sypher?

Take a look at the website in the videos section. there is a couple of good ones there. There should also be some coming out from the etoc.

JuanSG I got your email and will contact you tomorrow. Sorry for the delay.