I am building a 36% 3d plane and was wondering if futaba hv servos are worth the money over the hitec hv servos? Specifically rudder. I just want to run one servo in the tail in my pau edge.

Hitec 7980TH @ HV

Rutnbuc

Hitec 7980 is my pick as well.
got them in 3 40% so far with no issues.

Those hitec 7980 aren't even close to a futaba 9157 and that's not a new futaba HV servo .

https://www.flyinggiants.com/forums/...d.php?t=112514

I work at a hobby shop and can get just about any servo the only reason to buy hitec's is there warranty and service which is awesome . I started buying futaba 9157 then there new 9075sb a few years ago .last year I outfitted my new plane with bls172 and couldn't be happier .

Take a look at a Savox 1270TG. If you have questions please do not hesitate to PM me


Brian

+1 on the savox 1270TG

Originally Posted by abobo808

Haters are everywhere on flying giants nowadays they'll be a thread about a 3dhs and extreme flight plane and someone always jumps in there and say take a look at this pilot rc plane

I don't have anything against those manufacturers just using as example

You can't beat the MKS HV777 servos, all aluminum case. titanium gears and high volatage and 520 oz/in torque.

Originally Posted by vegasking1961

You can't beat the MKS HV777 servos, all aluminum case. titanium gears and high volatage and 520 oz/in torque.

Iv'e sure decided to go with these in my 42%. I had always thought I'd go with JR 8711's, but the more I read about and see these, I'm pretty much convinced.
On the thread note though, I have Hitec's 7980's and I can say they have worked great for me too.
Pick your poison ..................

Originally Posted by vegasking1961

You can't beat the MKS HV777 servos, all aluminum case. titanium gears and high volatage and 520 oz/in torque.

You guys are unbelievable you just can't help it can you

This isn't a mks and savox thread