09-06-2008, 11:04 PM
|
|
|
|
|
Joined Apr 2008
31 Posts
|
Drill guide for EVO 58, Need to drill prop and spinner.
Hello all, I have my new Mejzlic 24x10 prop and will be buying a carbon spinner. Not sure if it will be Pete's Models or TBM.
At any rate I need to drill these both. I've never done it before and need a template or a guide I can purchase. I know I can buy these items pre drilled for some engines but I never see EVO in the lists of pre drilled availability. Does anyone know if TBM can send me a prop spinner pre drilled for an EVO 58. Should I send them my prop too? Thanks in advance. Miles |
|
|
|
|
|
|
09-06-2008, 11:45 PM
|
|
|
|
|
|
Joined Jan 2007
440 Posts
|
Re: Drill guide for EVO 58, Need to drill prop and spinner.
Hi Miles,
Order you self drill jig from RCS for the ZDZ engine. This drill jig has two patterns one for large bolts, 5mm bolts and one for smaller 4mm bolts. You want to use the smaller pattern, 4mm bolts, it is same as smaller ZDZ engines up to 80 cc, and same as Evolution ( MVVS) The drill jig is $25.00 ( may be 30.00 now) but it is good investiment. Regards, Zee |
|
|
|
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
Similar Threads
|
|||||
| Category | Thread | Thread Starter | Forum | Replies | Last Post |
| New 28% Wild Hare Extra 300 84 Red Black Yellow | FlyinTiger | Airframes and Kits | 140 | 08-23-2013 01:09 PM | |
| What Spinner for Vess Prop 15x6 | pitviper51 | Nitro Power | 9 | 02-16-2008 07:48 AM | |
| Prop Torqueing Method?Procedure Best Known ... | rdgood | Gas Engines | 14 | 04-24-2007 09:32 AM | |
| Drilling a Mejzlik prop | plaster93 | General Discussion | 3 | 01-30-2007 09:45 PM | |