05-28-2007, 04:51 AM
|
|
|
|
Maitland, NSW, Australia
Joined Jul 2006
197 Posts
|
esskay 400xt will this be ok for a reflex 3d?
hi guys
I already have a esskay 400xt and jetti 8 amp controller and was looking for a new home for it. Im thinking about a hobby lobby reflex but am worried it will be a little under powered. The motor is rated for model up to 16 oz and the reflex is stated to have a flying weight of 13 to 14 oz. I will be using a 3 cel 900mah pack. Will it still hover with this combo? Any help and advise is much appreciated. |
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
Similar Threads
|
|||||
| Category | Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone know of a good 3D setup procedure? | Westbender | General Discussion | 6 | 07-14-2006 11:21 PM | |
| Does any one make a real .40 sized 3D kit/arf | rdgood | Groundschool: 3D Flying and Aerobatics | 12 | 06-13-2006 10:37 PM | |
| Great Planes, Flat Outs 3d?????? | Lizano | Foamies | 18 | 02-05-2006 10:43 PM | |