 |
 |
 |
|
|
|
|
| ||||||
|
|
|
 |
||||
|
|
|
||||
| Welcome to The FlyingGiants Community! We're all about fun, and inside you'll find the greatest, friendliest, and most helpful group of people around! If this is your first time visiting, please check out site, and click here to sign up! We hope to see you soon!! |
|
|||||||
04-17-2007, 03:26 PM
|
#1 |
|
Bad-ass Super Contributer!
 
Join Date: Dec 2006
Location: ISRAEL
Posts: 633
|
Question about interference carbon with 2.4Ghz
Hi guys,
i was thinking about using some carbons plates inside my Yak30%.. plates of the rudder servo, plate of the electronics.. almost everywhere inside the fuselage that there is electronics/fule tank/servos.... with normal PCM Receiver, i didn't had any problems with my Airplanes...... never.... but this 2.4Ghz have "short" antennas... and i can't take them out of the body like i did with the long PCM RX antenna.... what you guys think? all this carbon plates will cause a crash/lockout? Thanks.. |
|
|
|
04-17-2007, 03:55 PM
|
#2 |
|
Bad-ass Super Contributer!
Join Date: Jan 2006
Age: 24
Posts: 2,768
|
Re: Question about interference carbon with 2.4Ghz
i use carbon and have had no problem - as long as it is isolated from direct contact all should be fine
|
|
|
|
 |
 |
 |
 |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FlyingGiants Exclusive! Introducing The Futaba 12FG, Modules & More! | madmax | Leading Edge Homepage Article Discussions | 473 | 01-24-2010 11:01 AM |
| Interference Question????? | MetHerInBaghdad | Workshop Skills | 5 | 04-30-2007 10:18 AM |
| What are possible sources of interference on 2.4GHz | saflyer | Radios | 18 | 04-21-2007 06:26 AM |
| E-FEST News Flash! Oh Snap! Futaba Goes 2.4! | LeadingEdge | Leading Edge Homepage Article Discussions | 51 | 03-18-2007 01:51 AM |
| Carbon Fiber Tubing Question | HighRoller | General Discussion | 8 | 01-06-2006 06:32 PM |
