|
| ||||||
| Welcome to The FlyingGiants Community! We're all about fun, and inside you'll find the greatest, friendliest, and most helpful group of people around! If this is your first time visiting, please check out site, and click here to sign up! We hope to see you soon!! |
|
|||||||
|
|
#1 |
|
ZOOM & BOOM
![]() Join Date: Feb 2007
Age: 53
Posts: 332
|
Help!!!!!!!!!!! My super Tigre 2300 will not stop running, I use a Perry Carb, I've adj my throttle but it still will not shut down. What can I do???????????
|
|
|
|
|
|
#2 |
|
I'm Watching You!
![]() ![]() |
You have an air leak somewhere. I havent had a Supertigre in years, but I think they still have a rubber o-ring just below the carb on the venturi tube that seals the carb from the inlet. Check to make sure this o-ring is still there, and not cracked or broken. Other than that, I would check the rear case cover and make sure the screws are tight. If that isnt the case either, I would ask how old the engine is? You could perhaps have an airleak at the front of the crank shaft, through the front bearing and seal.
__________________
"Hey at Joe Nall I personally saw Tank kick a kitten in the face!" --66Stang J'Tec Radiowave 3D HobbyShop Aircraft International |
|
|
|
|
|
#3 |
|
Bad-ass Super Contributer!
![]() |
Try squirting some motor oil around the carb base were it meets the main body . Run it and if it still won't shut down it's probably the front bearing .
__________________
Good Friends and Great Flying rcbuzzards.com |
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| super tigre 51 | katana | Nitro Power | 8 | 12-19-2009 02:35 PM |
| Super Tigre 4500 (ST 4500) | Dhanni | Nitro Power | 19 | 03-25-2009 12:39 AM |
| Super Tigre G-2300 | Baker | Nitro Power | 22 | 02-27-2008 09:33 AM |
| GMS 1.20 or Super Tigre G2300 | 2robinhood | Nitro Power | 2 | 01-25-2007 08:28 PM |
| Super Tigre 2500???? | analog_boy | Nitro Power | 8 | 01-24-2007 12:19 PM |