Throttle Mix on 10X

[haste232]

Hi Guys
Does anyone know how to mix control surface ATV to throttle settings on a 10X, using throttle as master. I don't mean having a bit of down elevator on idle on the down line. I want to know if you can mix for example elevator movement of say 100% ATV at 30% throttle and below and say 50% elevator ATV whenever you throttle up beyond a that point. That is to mix the ATV to throttle, not an actual mix where to slave moves with the master. Does that make sense? I know you can do it on the 14MZ, but can it be done on a 10X ?
Thanks

[Boulder]

Hey haste,

Good to see you here!!

I'm going to move this into another forum so you can get the answer you're looking for.

Welcome to the Giants!!!

[tl3]

Hi, don't try to use the throttle as a master. The throttle should simply be the switch that turns the mix on or off. I do the same thing but with ail - increased ail rate for upline snaps and such. The mix is ail to ail - the slave setting being the higher rate - using the throttlestick as a position switch that activates the rate at roughly 90% stick position. In you case the mix would work as elev - elev. The offset function allows you to determine where in the stick travel the mix becomes active.
Hope this helps.
t

[haste232]

Thanks, I will try this.