| Thread Tools |
| This thread is privately moderated by Bunky F. Knuckle, who may elect to delete unwanted replies. |
05-31-2017, 11:36 AM
|
|
Trader Rating: 9
|
|
|
$1.00 USD
Buyer pays shipping
Found
4.5 or 5" spinner aluminum
Wanted!! I am in need of either a 4.5 or 5" aluminum spinner for my recently completed CY Models FW 190. A pointy 4.5" spinner just isnt gonna cut it for scale events.... I would prefer a 2 blade spinner, as that is what prop I am using on my engine.
PM me for quicker response if you have what I am looking for, or even know of a place where I can buy one. |
|
|
Last edited by Bunky F. Knuckle; 05-31-2017 at 08:06 PM.
|
|
|
|
06-01-2017, 11:52 PM
|
|
|
Trader Rating: 144
|
|
|
Was just about to post mine and seen your post. I just decided to run a 3 blade. 5" undrilled and polished. 2 blade cut. I Countersunk the retaining screw holes to accept the included metric SST FHCS
Sending a PM |
|
|
Last edited by crankcase; 07-30-2020 at 06:02 PM.
|
|
06-02-2017, 08:03 AM
|
|
|
Trader Rating: 2
|
|
|
I have a topflite one was drilled for dle55
|
|
|
|
|
06-05-2017, 05:09 AM
|
|
|
Trader Rating: 4
|
|
|
I have a 3 blade spinner for the T/F Fw190.
|
|
|
|
|
06-09-2017, 05:15 AM
|
|
|
Trader Rating: 9
|
|
|
|
Thanks for the replies and PM's. I found a spinner. Bought one from Crankcase. Thank ya, Harlan!
|
|
|
|
