What setup for a TOC Yak54 35%

[EDGE-540]

What setup for a TOC Yak54 35%

1- what servo's to use on the wing,ruder,elev .
2- what battery and regulaor to use ( i have 2 1 mpi 6.0& 1 mpi 5.4 ) .
3- what about smoke sys .
4- my engine is da- 100 what prop do you prefare .


thanx

[EDGE-540]

no One

[wildhare]

Don't use a regulator. Use 1 or 2 2300mah A123 packs with either 1 dual output super-switch or 2 regular switches with deans connectors on the input.

Or better yet use the new Spektrum AR9100 receiver and 2 A123 packs directly into the receiver.

Either way, regulators are out now.

TF

[EDGE-540]

I HAV OLERADY A 1- LIP 5600 2- LIP 2600 2- 6V IMP SWETCH 1 5.6 MPI SWETCH
ALL USE FOR THE AIRPLANE

5600 + 6.0 V MPI + REG + SPEKTRUM AR910
2600 + 6.0 V MPI + REG + SPEKTRUM AR910 AUX

IS IT GOOD ??

[aerowiz]

i have one of these aircraft.

it started with two rx's and two 3600 mah nimh packs.

it now has a power expander/turbo reg with two 4800mah packs feeding all the 5955 servos.

the difference was night and day. honestly. i put it down to the fact that a single power or even two power leads into an rx does not supply enough amps to power amp hungry servos.

for example, i was having a hard time with nice knife edge loops using just rx's, i swapped to the pxpder/trbo reg setup and i was astounded by the difference.

smoke systems on film covered planes are a real pita. unburnt fluid gets under the seams and creates a problem.

for a prop, i use a biela 27x 10 carbon prop. really good 3d/imac perfromer.


when you see talal next say hi to him for me. i actually bought my yak from him when i was in saudi.