 |
 |
 |
|
|
|
|
| ||||||
|
|
|
 |
||||
|
|
|
||||
| Welcome to The FlyingGiants Community! We're all about fun, and inside you'll find the greatest, friendliest, and most helpful group of people around! If this is your first time visiting, please check out site, and click here to sign up! We hope to see you soon!! |
|
|||||||
10-07-2008, 07:23 PM
|
#1 |
|
Flyin' Around
 Join Date: Feb 2008
Posts: 6
|
question on servo travel an resolution
I read in the instructions for my hitec digital servos that the normal travel was 120 degrees, and that the servo could be programmed to travel up to 180 degrees. It further states that if the travel is increased to 180 degrees, resolution will be lost as the number of steps remains constant, therefore more movement per step.
Frequently I need to reduce travel, and I do that in the transmitter which also causes a loss of resolution. My question is, if I use the servo programmer to reduce travel do I INCREASE resolution because the same number of steps will be used for less movement? |
|
|
|
10-09-2008, 01:51 PM
|
#2 |
|
Bad-ass Super Contributer!
 Join Date: Mar 2006
Location: Poway, CA
Posts: 704
|
Re: question on servo travel an resolution
It's always best to shorten the control horn to reduce the amount of control surface travel needed in order to obtain maximum resolution at the surface. Next best would be to limit the travel with the programmer and the worst by reducing the EPA in the radio. Ideally you should use 125% EPA and D/R for your highest rate to get the most out of the transmitter too, although some argue anything over 100% doesn't help resolution.
Mike Mayberry Hitec RCD USA. Last edited by Mike Mayberry; 10-09-2008 at 02:05 PM. |
|
|
|
 |
 |
 |
 |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Kit question...Dalton extra 260 | TonyThomasian | Airframes and Kits | 7 | 08-25-2008 12:39 AM |
| 35 % edge servo question | 3DROCKET | General Discussion | 5 | 08-11-2008 06:59 PM |
| Personal hitec 5955 test!!! | Extra260 | Radios | 161 | 12-18-2007 11:37 PM |
| Servo Resolution | Edge 540 | Radios | 17 | 12-02-2007 08:24 PM |
| Servo Tester/Servo Lab Question | Edge540 Freak | Radios | 3 | 11-15-2007 01:32 PM |
