Good airframe for OS120-III

[wgdenge]

OK, I can't decide?
Looking for good airframe for a new OS120-III I have sitting in the box.
I already have a 2.6, and 3M CompArf YAK, so I am looking for something different.

Something FUN.

I know there must a few ideas...

Cheers,
wayne

[ULTIMATE1]

GOLBERG PITTS MONSTER
http://www.rcgroups.com/forums/showthread.php?t=455572
Check out the review my buddy has one awesome with OS120-III Fun? HAL YEH!!!

Wingspan:60" Top 58" BottomWing Area:555 sq. in.Top; 534 sq. in BottomWeight:178 oz.Length:56"Wing Loading:23.5 oz/sq. ft.Servos:7 (5 Standard, 2 with 100 oz. torque)Transmitter:JR 9103Receiver:JR 700Battery:JR1400 4.8 voltsMotor:Thunder Tiger 120 w/J-Tec Pitts mufflerManufacturer:GoldbergAvail. From:GoldbergRadial/Cockpit:Wright RC


What is Yellow and Blue and can be performing all over the skies? With some advanced skill level, the Carl Goldberg Pitts Monster ARF can fulfill that statement with pride. This is an offering that has resulted in some great engineering, construction and hardware. If you are 'into' larger 'bipes', this might be your next hangar-mate!

Kit Contents



Kit Includes:

• Iron On Covered wings and fuselage
• Quality hardware
• Pre-Bent 2-piece landing gear
• Quality tailwheel setup that doesn't strain the rudder
• Pull-pull rudder hardware
• Fiberglass cowl/wheel pants

Kit Requires:

• glow engine -- 1.08-1.20 2stroke or 1.20 4-stroke
• Muffler (inverted mount engine)
• 4+ channel transmitter and 5-6 servos, plus 4 extensions
• Misc completion items & glues

All the supplied hardware was used with only one exception...I chose to change the

[RyDar]

Just wondering if anyone has a cowl for one of these discontinued Pitts Monsters????? I need one desperately