smart-fly eq6 aileron setup

[jacksons air]

Im probably having another dumb ass moment but i need some input on this one! This is my first time using anything of this type or setup. My normal setups i use channel 1&7 for the ailerons and bought the eq6 because im using multiple servos per wing panel & rudder. I figured this would be the trick set up for adjusting all servo centers and endpoints, my futaba manual doesn't state any other channels for ailerons but the problem i see is that channel 1 on the eq6 is one of the channels that aren't adjustable. This was the main reason for purchasing this product.
im using a futaba 9 super cap and 319 synthesized reciever. If someone could walk me through this i would be greatly appreciative.

[phippsj]

Email or call Robert at Smart-Fly . Robert is very friendly and can walk you through it. I'm the most computer-challenged person I know, and he helped me with a quick phone call.

You will love the EQ6 after you figure out how it all works.

[sweetpea]

Its very simple. The EQ's don't care what channel you use for what. They are labeled A-E etc.

You can put the ailerons on Ch A and B then simply plug those channels into your RX in the correct slots. So for example A would be Ch 1 and B would be Ch7 for you.

[rrritchey]

Hi Blake,
We had to make a decision on what channels were not programmable and we picked the end two. For a Futaba receiver I suggest you put the Rx channel 1 (aileron) on Eq6 channel 2, Rx channel 2 (elevator) on Eq6 channel 2 and Rx channel 3 (throttle) on Eq6 channel 1. You should then be able to go in order (Rx ch 4 to Eq6 ch 4) for the rest of the channels in general. Let me know if you have any other questions.