VICTOR'S HILLTOP SQUADRON

[Mojo]

bai tnx for keeping my lipo,abot n inyo order bai?pila imo nabayaran?

[Hansolo]

Cheap. Very Cheap Mojo. Less than ChocoMucho's CF blades.

[Hansolo]

My Wing is in the heli hospital.

[Astang_Astang]

hunsay nahintabo bai?

[riley]

Gib,
what page yung programming ng ESC supersimple 50A? Yung kay Hansolo ESC kailangan e program para makuha ang auto range ng throttle. Ayaw mag andar motor.

Your hk 450 heli is already complete, ready for test flight anytime you're free.

[Astang_Astang]

Post ko uli sir,


2. Turn on Rec, ESC, then Xmit with throttle on full, listen to beeps:
3. Musical tone, then 1 beep indicates that battery type can be programmed. This is repeated three times, then same but 2 beeps, then 3 beeps, 4, 5, and 6, all repeated three times, and it starts all over again. When you hear the one you want, go to 1/2 throttle. Here is what they mean:
ONE=Battery
TWO=Throttle
THREE=Brake
FOUR=Direction & Cutoff
FIVE=Timing
SIX=PWM setting
4. Next you select the choice within that option, with beeps coded to say where you are, again each choice is repeated three times, and when you hear the one you want, go back to full throttle, here they are: (Short-Long)
1-1 = NiCd
1-2 = 7 cell LiPo
1-3 = 6 cell LiPo
1-4 = 5 cell LiPo
1-5 = 4 cell LiPo
1-6 = 3 cell LiPo
1-7 = 2 cell LiPo

2-1 = Auto throttle range
2-2 = 1.1ms to 1.8 ms from Recvr
2-3 = Accelerate Fast
2-4 = Accelerate by ramp-up

3-1 = No brake
3-2 = Soft brake
3-3 = Med
3-4 = Hard brake

4-1 = CW rotation
4-2 = CCW rotation
4-3 = Cutoff soft (When battery low)
4-4 = Hard cutoff

5-1 = 2 to 4 pole motors
5-2 = 6 to 8 pole motors
5-3 = 10 to 14 pole outrunner
5-4 = Hi RPM outrunner (I think >20k)

6-1 = 8 kHz PWM for low RPM
6-2 = 16 kHz for outrunners

When done either:
A-Go full throttle to select another
B-Go low throttle to end and save
and you will get a long beep, and "Bob's your uncle"

Next startup will give 2 beeps to confirm all is OK.

[Astang_Astang]

Many thanks sa heli sir, Bukas cguro sir, tawag po ako sayo sa morning

[riley]

Thanks Gib,
Pag punta na lang natin sa field paki dala tail boom support. Madali lang man ikabit. Gnite, tingnan ko pa heli ni Hansolo.

[Astang_Astang]

hehe ok po, dalhin ko yung support

[Hansolo]

Whew my heli is....I don't know what happened...

[gouki74]

why hans? what happened to your heli?

[Hansolo]

Gouki,

I just got fed up. Remember for the last 3 days I was tuning my heli to death. Then I went to flip the idle swich & it just pitched down, good that I was quick with up pitch. Nothing serious, but it did bang to the ground taking off the canopy. When I tried to start her up again, the motor won't start. I was just tired of it all & needed a 2nd opinion, who better than Riley, so to the heli hospital it went.
Turns out it just needed to re-program the 50m SuperSimple esc to 2S lipo coz it wont start with the 3S setting. Then fine tuned the normal throttle curve. Tomorrow I fine tune the Idle TH curve in relation to the Normal curve. All I wanted was for my heli not to sag when switching from Notmal to Idle & back. I left my Wing be & focused on the HK450, now all I need is a gyro & the HK is flyable. Whew.

[gouki74]

so now your esc is set for use wih 2s lipos? your supersimlpe esc doesn't sound super simple (to use) for me

[Hansolo]

It used to be. Default you just plug & play, even if you have a 4S lipo. It's still a good esc, just weird.

[Hansolo]

Attention DX6i users.

http://publications.horizonhobby.com...com&x=bead1e5a