El-glider programming a JR 12X

[affas]

Just received my new JR 12X and trying to setup my electrical glider with dual aileron servoes and dual flap-servoes. It is a recomended setup in the Programming guide but it is for non-el gliders and I can not get the engine to work. Any out here wich has a good recipe?

Thanks,

Alf Hansen

[AWorrest]

Alf,
Before you start programming a motor glider, you ought to decide if failsafe is important. If you are using an older AR7000 receiver, it may have only smart failsafe. That means only channel one will go to a preset position if you go out of range. All the other channels will simply hold their last positions. On the nine and twelve channels receivers there is the option of having preset failsafe for all the channels. The newer AR7000 receivers also have this option but it is not mentioned in the instructions. If your receiver only has smart failsafe and preset failsafe on the motor is important to you, you should consider using the ACRO rather than the GLID programming. Only ACRO puts the motor on channel one where there is always preset failsafe.

Let me know which configuration you wish to use and we’ll take it from there. Sent you a PM.

Allan