Welcome to The FlyingGiants! - please login or click this bar to join our community...

HobbyKing.com New Products Flash Sale
 

Welcome to The FlyingGiants Community! We're all about fun, and inside you'll find the greatest, friendliest, and most helpful group of people around! If this is your first time visiting, please check out site, and click here to sign up! We hope to see you soon!!

Go Back   FlyingGiants > Giant Scale Planes > Gas Engines
Forgot your password? Create a new account


Reply
 
Thread Tools
Old 07-05-2009, 01:24 AM   #1
azza690
Doo It! Doo It!
 
azza690's Avatar
 
Join Date: Jun 2009
Location: aus
Posts: 95
Default throttle servo location????

I have a crrc pro 26cc and im mounting the throttle servo close to the EI should this
cause any problems if any knows??????
azza690 is offline   Reply With Quote
Old 07-05-2009, 01:35 AM   #2
Mike Busutil
Mind your business....
 
Mike Busutil's Avatar
 
Join Date: Mar 2008
Location: Yuma Arizona
Age: 29
Posts: 2,310
Awards Showcase
Japaleno Bad Ass: This is to say thank you for donating  funds to help bring Wesse to the 09 Joe Nall! - Issue reason: Thank you so much! 
Total Awards: 1
Send a message via AIM to Mike Busutil Send a message via Yahoo to Mike Busutil
Default Re: throttle servo location????

I am running my throttle servo about three inches from my duel Ignition setup on my 50% Yak....... never had a problem.
__________________

50% Hempel Edge 540 3W 275
50% Hempel Yak 55 3W 275
50% Hempel Version II Edge 540 3W 275
50% Hempel Yak 55 3W 275
100cc Hempel Yak 55 3W 106
50cc Hempel Yak 55 D.A 50
50cc Hempel Yak 55 40% Hempel Cub
Mike Busutil is offline   Reply With Quote
Old 07-05-2009, 01:44 AM   #3
azza690
Doo It! Doo It!
 
azza690's Avatar
 
Join Date: Jun 2009
Location: aus
Posts: 95
Default Re: throttle servo location????

tanks for the reply. I must of had a crook servo first time i installed a s the servo would chatter on idle making the engine rev up and down a little. i will go and install a new servo and see what happens
azza690 is offline   Reply With Quote
Old 07-05-2009, 02:04 AM   #4
Mike Busutil
Mind your business....
 
Mike Busutil's Avatar
 
Join Date: Mar 2008
Location: Yuma Arizona
Age: 29
Posts: 2,310
Awards Showcase
Japaleno Bad Ass: This is to say thank you for donating  funds to help bring Wesse to the 09 Joe Nall! - Issue reason: Thank you so much! 
Total Awards: 1
Send a message via AIM to Mike Busutil Send a message via Yahoo to Mike Busutil
Default Re: throttle servo location????

A good way to test that is check the throttle servo when the engine is off and see if the servo moves at idle, if not run the engine and check it again. If it does then you know it is caused by interferance.
__________________

50% Hempel Edge 540 3W 275
50% Hempel Yak 55 3W 275
50% Hempel Version II Edge 540 3W 275
50% Hempel Yak 55 3W 275
100cc Hempel Yak 55 3W 106
50cc Hempel Yak 55 D.A 50
50cc Hempel Yak 55 40% Hempel Cub
Mike Busutil is offline   Reply With Quote
Reply



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Throttle response vs. servo speed 2robinhood Gas Engines 8 05-03-2009 11:32 PM
Throttle servo very close to ign & batt?? Show871 Radios 17 12-19-2008 08:30 PM
Poor throttle response, throttle setup ideas? Peachey24 Gas Engines 15 11-26-2008 11:41 PM
throttle servo 58gx2 kfloyd General Discussion 7 03-25-2008 11:04 PM
Mini servo on throttle? Eury Radios 11 07-21-2007 02:05 PM


All times are GMT -5. The time now is 12:35 AM.

All Flyinggiants.com content copyright 2006-2012 by RCGroups.com, LLC except where otherwise indicated. The Flyinggiants.com logo is a trademark of RCGroups.com, LLC.
Please report any misuse of our trademarks or copyright violations using the contact form.
RCGroups Network :: RCGroups :: The E Zone :: Lift Zone :: RC Power :: Crackroll :: RC Cars

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2012, Jelsoft Enterprises Ltd.