Smart-Fly EQ II/Servo Sync

[antksmit]

Just installed an EQ II on my elevator servos (25% Cap 232), which until now have been mixed in the radio. The reversing worked out just fine, however, I noticed that they don't seem to be perfectly synchronized when moving at high speed. I didn't notice it immediately, but once I flipped into high rates it was obvious. Basically, if i give full up elevator, the left surface seems to lag. If I give full down, the right surface lags. I assume it has something to do with the endpoint adjustments, but I'm not sure exactly where to start. Any help would be greatly appreciated.

Thanks,
Anthony

[bodywerks]

Try the Smart-fly support forum, although it is likely just a difference between the two servos(common with Hitecs in my experience - not sure what you're running...) or something off with your geometry. Both servo arms need to be at the exact same angle at the neutral point, both pushrods need to be the exact same length, and both control arms need to be the same distance away from the hinge and have the same offset, if any. If any of these are off you will fight this problem indefinitely.

[daviddancer99]

Try setting your endpoints in your radio to 140% and adjust the endpoints using the EQ II.