TT TOC Katana 40% build

[Dino69]

Ok a few more things are done

the stabs are all set with two servos per stab i mounted a msa-10 in the tail i really didn't want to have to deal with all those servo leads from the stab so after talking with AJ and this is how he sets his stuff up thats what i went with much clean install. Also the rubber system is a little different not sure if i am going to say with it as it loads the servos allot this way but if one of the rubber servos burns out i can still bring the rubber back to center, i might go with a bell crank have to just think about it some more.

[PTS]

Where did you get the control horns?

[Dino69]

those are aero-works i like using those over drilling through the surface i never could get the exit hole just right, I have them on my 35% John has beat that plane up good a few times and never had an issue with them, Rocky uses them on a 37.5 yak also, you have to pre drill the block run the screw down and remove then wick thin ca in and run the screw back down and it down.

[Dino69]

Some more things i changed the rubber system back to a bell-crank the other one was loading the servos wrong and i would get a hard spot when moving the rubber by hand so instead of killing the servos i pulled all apart and went with a bell crank on the tray much better very smooth now. who ever said you didnt have to build an arf is kidding themselves I installed some more baffles on the motor box lite ply 1/16 back up with triangular stock and a small strip along the top keeps a close fit to the top of the cowl now this should force the air down and our the tunnel much better then just leaving it open.

[Dino69]

i am really stuck now waiting for batteries reg servos ext etc etc

[Dino69]

Still waiting for stuff the holidays really delay the shipping times, also on a side note revoc has design a set of wing bags for me which are really cool check them out

www.revoc.eu

[Dino69]

Ok the wings are done oh my god what a pain in the $ss i am sticking to heli from now on just kidding, I was able to pull the blue check off the wings with a problem, batteries are in just waiting for the fans for the Reg to come in and just a few more small things ill be done thank God i will post more pictures xmas is killing the shipping times

[Dino69]

Ok wings are done stabs are done now all i need is pipes and prop and we are ready the shipping times are insane this time of year once the pipes are in just need to clean up the covering add front wheels and lets fly. on the reg i will power the match box off the reg and the two other leads will plug into the Rx there are two regs in total with two 5200 lipos on board should be more then enough power for at least 6 flights

[3dAndrew]

It looks NICE Dino! I hope all is well with you and the family! Good luck on the plane and happy holidays!

[snap a saurus]

Boss, you're taking too much time, make sure it's mode One compatible.

[Dino69]

Mode one no problem i can flip the problem in the 14mz just for you baby SNAP A TT TOC Saurus

thanks andrew i hope to have it ready for new years weekend hope the weather holds out

[ejohn18]

Good looking BUILD!!!! Who's pipes and what lenth of headers did u go with? Gotta have one of these!!!!!

Thanks

Eddy

[Dino69]

i am using Re-3 with 14" headers they should show up before Xmas i hope

Are you a friend of Kyle's

[ejohn18]

Yes sir we flew yesterday.

[ejohn18]

Im working on a TT-TOC 35% yak with DA-100 and RE2's. I like the room in these planes easy to modify.

Eddy

www.3dflying.com