logo
Thread Tools
Old 05-08-2012, 04:09 AM
Dell Gatto Grande is offline
Find More Posts by Dell Gatto Grande
Flyin' Around
Joined Feb 2008
28 Posts
New Product
new PowerBox iGyro SRS 3axis+GPS

The all new PowerBox iGyro will make its first appearance in the public at the JoeNall 2012 event ,
where 10 to 15 units might be available for the lucky ones to be there!

http://www.rcuniverse.com/forum/m_11071402/tm.htm

...just for the record,PowerBox Systems GmbH is currently the only RC electronics manufacturer, which is officially licensed and regulated under DIN ISO 9001:2008 industrial norm.As a result of this award certification of development and production, PowerBox Systems GmbH covers there products with a 3 year guarantee.
Dell Gatto Grande is offline Find More Posts by Dell Gatto Grande
Reply With Quote
Old 11-28-2012, 10:28 AM
Dell Gatto Grande is offline
Find More Posts by Dell Gatto Grande
Flyin' Around
Joined Feb 2008
28 Posts
...a nice video from pickeringrc.com regarding the new PowerBox iGyro


The New 3Axis GPS! iGyro from...
Dell Gatto Grande is offline Find More Posts by Dell Gatto Grande
Last edited by Dell Gatto Grande; 11-28-2012 at 10:34 AM.
Reply With Quote
Old 11-28-2012, 02:21 PM
Dell Gatto Grande is offline
Find More Posts by Dell Gatto Grande
Flyin' Around
Joined Feb 2008
28 Posts
Problem with gyros is the wide speed range of our models fly and if the gain is not correct it will destroy/flutter from over-compensating your surfaces.

The new 3 axis iGyro from PowerBox with the GPS sensor that takes constant speed reading and adopts to the needs of the flight.

No more spending days out flying to fine tune mixes "throttle to aileron" "throttle to elevator" "throttle
to rudder" "rudder to aileron" "rudder to elevator" and so on and at the end get them all wrong because you decided to change the CG or try another prop


Video of the Master flying the new iGyro

SebArt - Avanti S Jet - YouTube
Dell Gatto Grande is offline Find More Posts by Dell Gatto Grande
Reply With Quote



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools