logo
Play   Pause

What Who/Where Thread/Post
New Post
60CC-SKYWING-91"SLICK360-GP61
Price and who is the USA distributor? Thanks.
New Post
New Post
Syssa Aircraft Performance
Have you tried US Chrome? http://www.uschrome.com/
New Thread
Prop to cowling distance. Thoughts?
Hey all you Yak owners out there... I'm trial fitting my 150 to the new 37.5, and was wondering what you folks were ending up with for the gap between the trailing edge of the...
New Thread
AR12120 Powersafe Lockout
Was flying my 120cc and the receiver locked out in the air. Airplane crashed. One interesting thing is that the receiver did not go into failsafe. My failsafe is set such that the...
New Post
New Post
Hangar 9 P3 Revolution 60cc ARF
1.5 lbs seems like a lot of weight. I'm running a DA 60 on stock mufflers with two pulse 2550 batteries in the engine box along with the throttle servo. I'm also using the White...
New Post
Procedure in installing a smoke system in a GP Escapade MX 30-35
Looks like you did a fine job. I plan on making the injector like the guy shows on U-tube. My friend has a new Sullivan smoker that he purchased and did not use so I will take it...
New Post
2.2 meter Skymaster A-10 build with EDF motors!!!
AWESOME work! I know what you mean about time... I'm almost 8 months into the Roban A-10 and my build is slow too. I'm really liking the AK scheme too
New Post
Flying Fields near Hugoton KS
wow, very nice find!
New Post
Procedure in installing a smoke system in a GP Escapade MX 30-35
Since I used a smoke oil injector, which has a lower flow rate than just a regular pressure tap, I used a 10oz tank. I get about 7 min of smoke, using it mainly during aerobatic...
New Post
FUTABA 18SZ
Thank you for your comments. But, why do I need receiver with telemetry capabilities? Is the telemetry part important for the Mercury PB to work properly? Recently I have...
New Post
Florida Freestyle Aerobatics Association - FFAA (Part 2)
If the pipes were any longer , they would exit at the tail wheel ..
New Post
Firewall bushing. Is this a good or bad idea?
I have both, I think for the firewall, use the 1/8" touch. To answer your question, I do not know if the 1/16th would be crush resistant. Probably should be OK, if you laminate...
New Post
New Post
Hangar 9 P3 Revolution 60cc ARF
Balancing Problem: I have the DLE 61cc single cylinder engine mounted with a pitts style muffler. I also have 2- 7.4V, 3,400 mAh TB batteries mounted to the engine box, using a...
New Post
EF/3DHS 79" Slick 580
Read on another forum it's a 65mm square pattern
New Post
2016 Carden 124" Extra 300 Pro (build thread)
SOHCAHTOA 20" x Arctan(1 degree) = 0.35" or about 8.7mm In order to do this correctly you need to measure the length of the right triangle's adjacent line to the pivot point...
New Post
Now Shipping! The 3DHS Edge-540 Demonstrator
I had a somewhat similar experience when my throttle servo failed and I set it down and it hit something and flipped over nose first. Only real damage I saw at first was the...
New Post