-
The Before... Overall in not to bad shape. Was well built but had a hard landing that did a number on the undercarriage. -
Design on tail -
OS FS200 four stroke, barely broke in -
One piece 72" wing -
minor damage to the belly pan -
Firewall still good and intact -
Most of the underbelly of the plane was gone. From the landing gear mount to the wing mounts and everything in between. -
The fuse was split horizontally nearly back to the tail -
Wing fitment and missing landing gear block -
Side view -
Aft wing mount section -
Aft bulkhead gone -
Starting to put the pieces back in like a jigsaw puzzle -
Aft bulkhehad -
Overhead view -
Trying to figure out where the landing gear went -
-
Landing Gear -
Other Side -
Front View -
Slowly fitting pieces together -
-
-
Rear bulkhead -
Coming together -
-
-
Wing Fitment -
-
-
-
New rear bulkhead -
-
-
-
-
Starting to look like a plane again -
New wing mounting blocks -
-
More fine tuning for wing alignment -
filling the cracks and sanding -
new landing gear plate -
-
-
-
-
-
Landing gear braces -
-
Fiberglass for reinforcement -
Final fit check -
Covering -
-
-
-
Motor Reinstalled -
-
Pinstripe and graphics -
All done and ready for the maiden!
Comments (3)
Add Comment