I'm setting up a 12 channel power safe receiver, The transmitter only has 10 active channels, can I some how activate the other two channels in the transmitter to use the last two channels on the receiver being aux 6 and 7 without using a srxl module, thinking there should be, why else make any receiver over 10 channels

Yes, turn on X-Plus in the binding menu

page 11

https://www.horizonhobby.com/pdf/SPM18100-Manual_EN.pdf

you have to activate the additional channels.

Use the manual? You make jokes!

I did use the manual, there not to helpful sometimes, it only explaines x plus, didn't say what I was trying to figure out

OK, checked out the link you guys sent me, I'm a dumb ass, I see now, thanks

You have interacted enough with me you should know I was busting chops

andy, if that was directed at me...yeah, of course I know..."manual? we don't need no stinkin' manual." tell you what's really sad is that I have the page number memorized.

Originally Posted by BarracudaHockey

You have interacted enough with me you should know I was busting chops

Yeah I Know

Originally Posted by FGNewbie

page 11

https://www.horizonhobby.com/pdf/SPM18100-Manual_EN.pdf

you have to activate the additional channels.

Got her working last night tanks to you and Andy, Thanks again guys.

Always a pleasure

Originally Posted by BarracudaHockey

Always a pleasure

Got another question, first time I have used electric retracts, always used air, how do you assign three retracts to the single gear channel. Also have a nose gear door that needs to be figured in also. Do you put one in the gear channel then the other two in aux channels and mix them together some how so they all work with the gear switch? DA!

Would like to use the sequenced in my dx 18 g2 to operate the gear

I've certainly not seen them all, but I've yet to see a set of electric retracts which do not have a controller/sequencer. Only takes one tx channel.

That's what I Thought