|
![]() |
|
Joined Dec 2006
715 Posts
|
Re: 3D_Kid's new build.
Here's the link to the charger review I did: https://www.flyinggiants.com/reviews...hp?product=171
|
![]() |
|
Joined Dec 2006
715 Posts
|
Re: 3D_Kid's new build.
Turns out it is binding, caused by the EZ-Connectors being too tight against the servo arm, which makes the rod fixed in one location. The thing is, if I loosen them they might fall off in flight. I fixed the ailerons, but the dang elevator servo binding is causing one side of the elevator to go down more than it will go up.
|
![]() |
|
Joined Dec 2006
715 Posts
|
Re: 3D_Kid's new build.
OK, found the solution, drilled out the hole in the servo arm a little bigger, put the EZ conector back on, used blue locktite, then CA'd the little nut that keeps the ez connector on the arm. Now I got to go back and do this method to the ailerons and rudder as well to ensure smoothness.
|
![]() |
|
Joined Dec 2006
715 Posts
|
Re: 3D_Kid's new build.
I've got a question about tomorrow, What will I need to do different when taking off, landing with an electric? I've always done glow and this is new. ALSO what do I need to do in a hover to get the sweet spot on the throttle to keep it from going up or down? Thanks, Ken.
|
![]() |
||
|
Re: 3D_Kid's new build.
Quote:
![]() |
|
![]() |
|
|
Re: 3D_Kid's new build.
I think you should fly it a bunch until you get a feel for where the plane hovers... then program the throttle curve to slow down when it gets close to the "hover power sweet spot"!!!
My 35%er was doing the same thing... up down up down... it wouldn't sit still. Then I programmed the throttle curve to slow down slightly around a hover... and it worked great. Good luck. Craig Rideout |
![]() |
|
|
Re: 3D_Kid's new build.
yes sir!!!
![]() this is correct, every plane is different and you'll just have to "feel" where it needs to be flattened out a little to give you that sweet spot. I had a foamy doing that, one click up it would go vertical and one click down it would tailslide. |
![]() |
|
Joined Dec 2006
715 Posts
|
Re: 3D_Kid's new build.
No wonder!, I just read the instructions, it requires AT LEAST 3.1GHZ!! My laptop was new this past August, it's like a 2.0 ghz dual core. I can't believe this thing.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
![]() |
|||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Aviation Design(Godfrey) 35% Extra 260 BUILD THREAD | GremlinX | Build Threads | 101 | 03-06-2019 07:07 PM | |
Build: Kimball-Somenzini Python 100 | Reza | Build Threads | 570 | 10-29-2017 02:57 PM | |
Aerotech 42% - Twin Build | Fixed Wing | Build Threads | 175 | 12-13-2009 11:48 PM | |
Ultimate Carden 260 Build by LJJ | LJJ | Build Threads | 330 | 03-25-2009 11:40 AM | |
H9 35% 260....its cheating to call it a build thread!!!!! | Cracky | Build Threads | 105 | 09-04-2008 10:48 AM |