Thread Tools |
This thread is privately moderated by 3D-Seth, who may elect to delete unwanted replies. |
![]() |
|
|
My First Design . . .
My first foamy design. Made for F3P/Freestyle contests (such as the ETOC). I have the first parts cut out:
1 Wing 2 SFG/Wing Struts 4 Aileron SFG thingamajiggers (whatever they are called Horizontal Stab 2 Drag Plates minus the holes being cut (you can see the circles where the holes will be cut in the pic 2 Wheel Pants/Landing Skids Whats left to cut out: 1 Wing Vertical Fuse/Rudder Horizontal Fuse 2 Tail flex prevention pieces and I think that is it. Have to wait for more foam/carbon fiber to show up sometime this week before it can be finished . . . Setup will be: Motor - Hacker A10 9L ESC - Castle Creations Pheonix 10 Servos - Dymond D47 on Rudder/Elevator 1 Futaba 3154 on ailerons RX - JR 610 UL on one, FMA Direct 5 Ch on another one Batts - TP 350 mah and 480 mah 2s1p Seth |
|
![]() |
|
|
Thanks!
I get my foam from RC Foam, www.rcfoam.com they also sell carbon fiber which I get from there as well. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
![]() |
|||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Gallery | DSC03841 | snap a saurus | General Discussion | 0 | 05-20-2007 08:45 PM |
Composite 2.3 help | Derek Hunter | Airframes and Kits | 4 | 02-18-2006 12:34 PM |