Had two wing servos went bad on my 42% yak while practicing IMAC. One servo is almost locked up and other burned but now my port 2 is dead on eq10. I can move right ailerons over to port 9, but my question, is the eq10 repairable, and can I trust it?

Send it in to Smart-Fly to be repaired.

It's not a question on sending, but can they repair?

I had my deans connector replaced by them but not a port repaired.

Hi,
I am not sure if this would be repairable. I would have to look at it but if its the IC that dries the signal output then no. This IC has gone out of manufacturing. Its really hard to say about reliability. In general I would say it should be OK but damaging the output drivers on an IC could cause other issues. I wish I could give you a definite yes or no on this.

Originally Posted by bobzilla

Had two wing servos went bad on my 42% yak while practicing IMAC. One servo is almost locked up and other burned but now my port 2 is dead on eq10. I can move right ailerons over to port 9, but my question, is the eq10 repairable, and can I trust it?

Thanks for your help, and after resetting and plugging in know good servos, all is well