Originally Posted by czechalien

Final setup

Nice job
Look forward to seeing the flight

I've received 1270's and the gaz engine this week.
I hope i will have a little time to put it in the Extra the week-end and makes some photos

According to you, how many "mAh" do you think i need for powered the 5 x 1270TG, one 0220mg for the gaz and the ignition.
Iwould like between 4-5 fly beforge recharge the lipo

Guillaume

Originally Posted by Gu1ohm

Nice job
Look forward to seeing the flight

I've received 1270's and the gaz engine this week.
I hope i will have a little time to put it in the Extra the week-end and makes some photos

According to you, how many "mAh" do you think i need for powered the 5 x 1270TG, one 0220mg for the gaz and the ignition.
Iwould like between 4-5 fly beforge recharge the lipo

Guillaume

Im running (2) 2600 Lipos into a wolverine switch. Tech Aero IBEC to RX for ignition and all the same servos as you. I easily get 4 to 5 flights.

Originally Posted by gapple12

Im running (2) 2600 Lipos into a wolverine switch. Tech Aero IBEC to RX for ignition and all the same servos as you. I easily get 4 to 5 flights.

Ditto. Same setup and 4-5 flights at 10-12 minutes each is certainly doable.

Same here fwiw. My 2,600 Glacer 2S aren't new new anymore. I'm getting 3-4 10 minute flights easily.

Thanks all for your answers.

In fact i will use only 2 2cells lipo with an Emcotec 2001RV for power all my savox and ignition (no a third lipo for ignition, only the two on the dpsi).

So according to you, 2x 2600mAh is enough for 4 runs of 10minutes?
Thx

It is for me, with my DA-70.

Originally Posted by Phil Griffin

It is for me, with my DA-70.

Yup, same here

Originally Posted by Phil Griffin

It is for me, with my DA-70.

The engine is a Torqpro TP60

Are we talking about Savox SV0220MG for gas? (i have DA70)

Thanks Phil, Looking forward to seeing photos of the ally TnT u/c and your J&J tail wheel installation :0)

Originally Posted by pittsdriver

Thanks Phil, Looking forward to seeing photos of the ally TnT u/c and your J&J tail wheel installation :0)

Took a few quick shots. They're not the best. One is a set of aluminum gear on my old 91, which I painted. The other is on my newest 91. The new gear were covered in CF covering by a buddy. Also encluded is a shot of the tail gear on my Demon.

Originally Posted by shmulik64

Are we talking about Savox SV0220MG for gas? (i have DA70)

Yes, 0220mg for gaz ans 1270tg for all surfaces in 7,4v

Just got my first EF plane Also my first DA (the70) Sure is a nice looking motor, so how come DA can't supply a simple mounting template?? I've searched the net & this forum & can't seem to find one...

Originally Posted by rcnorth

Just got my first EF plane Also my first DA (the70) Sure is a nice looking motor, so how come DA can't supply a simple mounting template?? I've searched the net & this forum & can't seem to find one...

Same as the DA60.

Originally Posted by ericb

Same as the DA60.

Ok but where do I find a template for a DA60? I could only find one for the DA50

Edit- Ok looks like the 50 is the same also.