I have a 100cc Hangar 9 Beast biplane and was wondering if the Super reg would handle it ok? Not sure if I should try it or not...

My setup is:
4x Hitec 5955's for the ailerons
2x Hitec 5955's for the rudder (May switch back to single 7950 for rudder later on)
2x Hitec 7955's for the elevators
and a Hitec 5625 for throttle
Power expander Pro
2x 2100mah 2s lipo for receiver power
Turbo reg currently installed

I've been using the Turbo reg in it with NO problems but always felt that it was overkill. Turns out now I need it for my new project (3DH 126" Slick), Power expander and Hitec 7950's dont seem to play well together under full lipo voltage (Jittering servos with unregulated lipos) but thats another story for another day....

I have a spare Super reg laying around and am curious if it will handle the biplane or should I just buy another turbo reg for the Slick?

Thought....opinions anyone?

Thanks

I had a super reg in my 2.6 ca yak with 9 5955's in .. It worked ok- well it never made a smoking hole with that setup.. Supposedly it will handle 8 8711's but then again you may be on the higer end of its range with your setup..

The SuperReg will work fine in a 100cc plane. The servos will only work as hard as they need to when pushing the mass of the plane around.

Thank You... I figured it would be ok but just wanted a second opinion.