This was my first gasser, I bought it March 2015. Steve Humunski of NJ (original posting of this very plane: http://www.rcuniverse.com/forum/arf-...-180-a-13.html) I bought it from, good guy! I took it home and began to modify it to my liking. It honestly didn't need much in the way of maintenance to fly. I just went wild buying parts I wanted for it. I wanted a certain look and feel for it for sure. My first flight I wing wagged in and put the gear through the wing skin. Fixed it easily and was back up in the air again. I've put about 30 flights on it thus far since Ive had it. I am in a constant state of bettering this plane .




Seagull Extra 260- modified
*This is how the Seagull should look!
IBEC for ignition
Modified Rudder assy. for 3D flight
repainted new Xoar sword propeller (sealed)
Secraft canopy 4mm bolts (red) flushmounted
Graphtech Carbon Landing gear
DLE 30 w/ Secraft carb intake funnel
Hitec servos/ Savox on the ailerons for faster response (see below)
No Limitz 3 inch spinner (white)
B and E graphix small extra 260 logos/ aeroshell
Callie Graphics Mt propeller logos/ Extra 260 large logos and fuselage sponsor graphics.
Robart joints swapped in on ailerons - better throw (original CA hinges break after 50 flights or so.)
Polished Jtec Muffler
flown on VP fuels only
Fortitude fuel tank
Miracle fuel dot
miracle single switch assembly
Modified cowl with baffles for improved cooling
Horizon hobby pilot 25%
Redwing Carbon tail wheel assy.
Red Fuel line- Taildragger RC
New Red 3/8" wire loom
Quickfire fuel starter
200 X 250 3K weave carbon plating added for rudder servo tray.
DuBro Red Servo Ball joint hinges all around
New Savox aileron high speed servos
6STAR red servo tray for throttle
Red servo safety clips
Aluminum thin plate inside base of motor box to prevent fuel drippage from carb damaging the motor box.