WOW, looks like my Timber will be delivered today!! That was FAST!!

Anyone try a 30cc gas engine? If so how does it perform?

Wonder if they are on sale because of the horrible paint match cowls!!!!!!

Originally Posted by Fentonflyers

I wish there were specs on the float kits they have. Not sure if the 1/4 or 1/3 scale would be better. I have a couple of sets of 30cc Avistar floats but they fall a few inches short of 80% of the fuse length. If I remember correctly they would be ideal around 54-56".

I was looking at their 1/3 set for my ESM 195 that is 107" span. I wanted plenty of float length for that long fuse.

Originally Posted by flyerman

I was looking at their 1/3 set for my ESM 195 that is 107" span. I wanted plenty of float length for that long fuse.

You can always make a glassed foam set.
http://www.seaplanesupply.com/

Originally Posted by AKNick

You can always make a glassed foam set.
http://www.seaplanesupply.com/

Nice!

Scored a scratch n dent today! Couldn’t pass it up so I am thinking of building this one electric and hopefully floats!!!

Has anyone used the leading edge devices for any extended amount of flying time. How do they compare to not using them, have you noticed any good or bad results from using them?

Originally Posted by rtn9105

Has anyone used the leading edge devices for any extended amount of flying time. How do they compare to not using them, have you noticed any good or bad results from using them?

Not yet, but I am getting ready to put them on. The only thing I have heard that do help keep the wing flying longer thus reducing wing drop/tip stall, and that they slow the roll rate a bit. So unless you are going to do rolling circles with the plane all day there is no disadvantage.

Originally Posted by AKNick

You can always make a glassed foam set.
http://www.seaplanesupply.com/

Ordered

Flyerman which ones did you get?

My dealer cannot get me one at the sale price

Originally Posted by denney47

My dealer cannot get me one at the sale price

I suggest ordering direct from Horizon.

Originally Posted by Fentonflyers

Flyerman which ones did you get?

60" deep "V" with the flat. Looks like it will be a good setup.
I also ordered a Timber. I couldn't take all of the positives without joining in.
I'm weak- no other excuse fits
I have a GP61 or a DLE40 twin needing a place to hang out. I'll have to check the cowl width for the twin.

Anyone know if the 15% sale is still going on?